MXBON 41433 UV ADHESIVE

UV light and/or visible light

MXBON® 41433 can be cured by UV light and/or visible light. The range of wavelength are 365nm、395nm and 460nm To obtain full cure on surfaces exposed to air, radiation 220 to 260 nm is also required. Fixture time and cure speed achieved depend on substrate used, bonding gap, UV intensity, exposure time and spectrum distribution of light source.

UV light and/or visible light

Initially cured The cured rate depends on substrates. Fixture time is defined as the time to develop the shear strength of 0.1 N/mm2 .

Initial time : 6 mW/cm2 @365nm, ≤ 10 seconds

Deeply cured

The cured rate depends on the type of light source、the wavelength range of the light radiated、light intensity energy and lighting time. The figure shows that MXBON® 41433 apply to different light intensity, glue layer thickness and cured speed.

Cured@30mW/cm2 , @365nm 80sec

Physical properties

Cured@30mW/cm2 , @365nm 80sec

Block Shear strength, ISO 13445

Cured@30mW/cm2 , @365nm 80sec

Heat Aging

Heat aged for 1 week @ 49℃ / 100% RH, tested @ 22℃

Block Shear Strength, ISO 13445

This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be use with chlorine or other strong oxidizing materials. Where washing systems are used to clean the surfaces before bonding, it is important to check the compatibility of the washing solution with the adhesive. In some cases, these solutions can affect the cure and performance of the adhesive. Users are recommended to confirm compatibility of the product with such substrates.

Keep adhesive in a cool and dry place. The storage temperature is recommended at 8 °C to 21 °C. For details, consult the Safety Data Sheet, (SDS). Shelf life is one years from the date of manufacture in the original container under the optimal conditions.

1. Avoid contact with skin and eyes.

2. If contact with skin, rinse with water.

3. If adhesive gets into eye, keep eye open and rinse with water thoroughly. Seek medical attention immediately.

4. Keep the material out of children’s reach.