MXBON 41132M UV ADHESIVE

MXBON® 41132M can be cured by UV light and/or visible light of 365nm、395nm and 460nm. To obtain full cure on surfaces exposed to air, radiation 220 to 260 nm is also required. Fixture time and cure speed achieved depend on substrate used, bonding gap, UV intensity, exposure time and spectrum distribution of light source.

Fixture time is defined as the time to develop the shear strength of 0.1 N/mm2 .

UV Fixture Time, ISO 4587, Glass microscope slides, seconds: 6 mW/cm2 @365nm, ≤ 15

UV Fixture Time, ISO 4587, Polycarbonate, seconds:

30 mW/cm2 @365nm, ≤ 10

100 mW/cm2 @365nm, ≤ 5

Tack free time :100 mW/cm2 @365nm, ≤ 20

Deep (1-3 mm) Fixture time : 100 mW/cm2 , ≤ 60

Cured @ 30 mW/cm², measured @ 365 nm, for 80 seconds using a glass filtered metal halide light source

Physical properties

Electrical characteristics

Adhesive properties

Cured @ 30 mW/cm², measured @ 365 nm, for 80 seconds using a glass filtered metal halide light source (samples with 0.5 mm gap).

Lap shear strength , ISO 4587

Polycarbonate

* substrate failure

Cured @ 30 mW/cm², measured @ 365 nm, for 80 seconds using a metal halide light source, (samples with 0.5 mm gap).

Lap Shear Strength, ISO 4587:

Polycarbonate

Aged under conditions indicated and tested @ 22 °C.

* substrate failure

This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be use with chlorine or other strong oxidizing materials. Where washing systems are used to clean the surfaces before bonding, it is important to check the compatibility of the washing solution with the adhesive. In some cases, these solutions can affect the cure and performance of the adhesive. Users are recommended to confirm compatibility of the product with such substrates.

Keep adhesive in a cool and dry place. The storage temperature is recommended at 8 °C to 21 °C. For details, consult the Safety Data Sheet, (SDS). Shelf life is one years from the date of manufacture in the original container under the optimal conditions.

1. Avoid contact with skin and eyes.

2. If contact with skin, rinse with water.

3. If adhesive gets into eye, keep eye open and rinse with water thoroughly. Seek medical attention immediately.

4. Keep the material out of children’s reach.

MXBON® 41132M has been tested base on biological evaluation. It could use in medical device industry.